Page EN-15
Delivery
Automatic regeneration
In order to make sure that the water softening
system works, the water softening system is
automatically regenerated at regular intervals.
The regeneration process of your appliance
begins with the drying cycle. The water and
energy consumption then increases and the
duration of the programme is extended. There
is no regeneration process in the short pro-
gramme.
The frequency of the regeneration process
depends on the selected water hardness:
°dH
Setting
Regeneration
process every X
programme cycles
0–5
H1
–
6–11
H2
10
12–17
H3
5
18–22
H4
3
23–34
H5
2
35–55
H6
1
Example ECO programme: with a water
hardness level of H3 and under laboratory
conditions, the duration of the programme in-
creases by 4 minutes. The energy consump-
tion increases by 0.02 kWh and the water
consumption by 2.0 litres.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the de-
vice functions perfectly. Carry out this test run
when the dishwasher is empty and without
any dishwasher detergent.
1. Open the tap completely.
2. Close the dishwasher door.
3. Press the button (1) to switch on the dis-
hwasher.
You will hear a signal tone and all LEDs will
illuminate briefly.
After a moment, the
ECO
programme LED
will light up.
4. Press the
P
button (12) repeatedly until
the LED to the right of the
programme
symbol lights up.
5. Start the programme with the but-
ton (13).
The programme begins after a few seconds.
6. Ensure that no water is coming out and no
unusual sounds can be heard.
7. When the programme is finished, an
acoustic signal will sound.
Switch the dishwasher off using the
but-
ton (1).
8. Slightly open the door to allow the moist
air to escape.
9. Close the tap.
If no water has escaped and no unusual noi-
ses have been heard, the dishwasher is rea-
dy for operation and you can now load it with
dishes.
Содержание HG6085E127635W
Страница 38: ......