
Page EN-14
Delivery
5. In order to equalise unevenness in the
floor and set up the dishwasher on a level
horizontal base, you can screw the four
adjustable feet in or out. There are slots
in the appliance feet around the circum-
ference. Insert a screwdriver and turn the
appliance foot.
Use a spirit level to set up the dishwasher.
Degree of water hardness
Hard water will cause calcification within the
dishwasher. Also, more dishwasher detergent
will be required to clean the dishes. Soft water
increases foaming.
For this reason, the degree of hardness of the
water has to be determined and adjusted even
before the first use. You can determine the
water hardness from your water bill or enqui-
re about the degree of hardness at the water
supply company. The appliance is factory-set
to a hardness level of “H3”.
Adjusting the water hardness level
(12)
(10)
1. Close the dishwasher door.
2. If the appliance is switched on, switch it off.
Do not allow more than 1 minute to elap-
se between the following steps, other-
wise the setting process will be interrupted.
3. Switch on the dishwasher using the but-
ton (1).
4. Press and hold the
P
button (12) until
LED (10) flashes.
Please refer to the following table for the
relevant water hardness setting:
°dH
LED display
Setting
0–5
H1
6-11
H2
12-17
H3
18-22
H4
23-34
H5
35-55
H6
5. Press the
P
button (12) repeatedly until the
required hardness level is displayed.
6. Around 5 seconds after you push it for the
last time, the dishwasher will automatically
revert to the normal display.
The hardness level setting is saved.
Содержание HG6085E127635W
Страница 38: ......