4
Preparation for the installation of the hot tub
a Type C or Type D circuit breaker with a rated current of 16 A (motor circuit breaker)
downstream of the Residual Current protective Device.
Recommended Type C circuit breaker
Hot tubs with two massage motors:
3× 16 A/C or D
Hot tubs with three massage motors:
3× 20 A/C or D
!!! THE HOT TUB MUST BE INSTALLED BY AN ELECTRICIAN WITH THE
APPROPRIATE QUALIFICATION ONLY !!!
2
Preparation for the installation of the
hot tub
Check the hot tub first before the installation Immediately contact the
seller in case any of the parts are broken or missing Make sure that all the
components correspond to your order Check the hot tub before every use
In case of any damage, do not use the hot tub
2 1
Preparation of the place for installation and connection to
electricity
The hot tub must be installed on a flat, sufficiently solid base plate, taking into
account the load-bearing capacity of the building. If the hot tub is installed outdoors,
we recommend constructing a concrete monolithic base slab with a minimum strength
(thickness) of 10 cm. It is important to also always select the load-bearing capacity of
the base slab with regard to the dimensions and the weight of the hot tub. Consult
your building supervisor. The weight is specified in the technical description of the
given hot tub. The tubs are prepared by us for an electrical connection of
3× 230 V/400 V~ alternating current. Therefore, use a circuit breaker 3× 16 A/C or D,
alternatively 3× 20 A/C or D and a Residual Current protective Device corresponding
to this connection. Furthermore, it is necessary to have a cable with parameters
corresponding to the rightful regulations for this type of connection. The cable must
also have 4 usable meters at the location of the hot tub, so that it can be pulled
through and connected to the control unit without complications. Do not route the
cable under the hot tub!
NO
YES
Содержание TP 700
Страница 1: ...USER MANUAL TP 700 ...