Unicorn 3101 User Manual
Copyright © 2008
Hanlong Technology Co., Ltd Page 27 of 29
located on the FXS Port Configuration page.
If call volume is too low when using the FXS port (ie. the
ATA is at user site), adjust volume using the Rx Gain
Level parameter under the FXS Port Configuration page.
If voice volume is too low at the other end, user may
increase the far end volume using the Tx Gain Level
parameter under the FXS Port Configuration page.
Ring Tones
This function lets you configure ring tone cadence
preferences. User has 10 choices.
The configuration, completed in Distinctive Ring Tones
block in the same page, applies to ring tones cadences
configured here.
6.1.7
Saving the Configuration Changes
Once a change is made, users should click on the “SaveSet” button in the Configuration
page, as follow:
The Unicorn 3101 will then display the following screen to confirm that the changes have
been saved. Please allow 5 to 10 seconds before rebooting the device.
6.1.8
Rebooting the Unicorn 3101
You can reboot the Unicorn 3101 by clicking on the “Reboot” button after each update to
the configuration page. Alternatively, you can reboot by unplugging the power supply of
the Unicorn 3101 and then powering it on again. If your Unicorn 3101 ever becomes
“stuck” or un-responsive, you can unplug the power supply to reboot it. Frequent
rebooting by unplugging the power supply is not recommended and should not be
necessary.
6.2
Configuring Unicorn 3101 via Voice Prompt
6.2.1
DHCP Mode
Follow section 5.1 with voice menu option 01 to enable Unicorn 3101 to use DHCP
