Unicorn 3101 User Manual
Copyright © 2008
Hanlong Technology Co., Ltd Page 24 of 29
and port of the inbound RTP packet last received by the
device.
Fax Mode
Default is
T.30
.
Fax Tone Detection
Mode
Default is
Callee
. This decides whether Caller or Callee
sends out the re INVITE for T.38 or Fax Pass Through.
Jitter Buffer Type
Select either Fixed or Adaptive based on network
conditions.
Jitter Buffer Length
Select Low, Medium or High based on network
conditions.
Distinctive Ring Tone
Default is
NO
.
Disable Call-Waiting
Default is
NO
.
Disable Call-Waiting
Tone
Default is
NO
. This is to disable the stutter call waiting
tone when a call waiting call arrived.
Ring Timeout
Incoming call will stop ringing.
No Key Entry Timeout
Default is
4
seconds.
Early Dial
Default is
No
. Use only if proxy supports 484 response.
Dial Plan Prefix
Sets the prefix added to each dialed number.
Use # as Dial Key
This parameter allows users to configure the
“#”
key to
be used as the
Send
(or
Dial
) key. If set to
Yes
, pressing
this key will immediately trigger the sending of dialed
string collected so far. In this case, this key is essentially
equivalent to the
Re(Dial)
key. If set to
No
, this
“#”
key
will then be included as part of the dial string to be sent
out.
Dial Plan
Dial Plan Rules:
1. Accept Digits: 1,2,3,4,5,6,7,8,9,0 , *, #, A,a,B,b,C,c,D,d
2. Grammar: x - any digit from 0-9;
a. xx+ - at least 2 digits number;
b. xx. ?at least 2 digits number;
c. ^ - exclude;
d. [3-5] - any digit of 3, 4, or 5;
e. [147] - any digit 1, 4, or 7;
f. <2=011> - replace digit 2 with 011 when dialing
Example 1: {[369]11 | 1617xxxxxxx} Allow 311, 611, 911,
and any 10 digit numbers of leading digits 1617
Example 2: {^1900x+ | <=1617>xxxxxxx} Block any
number of leading digits 1900 and add prefix 1617 for any
dialed 7 digit numbers
Example 3: {1xxx[2-9]xxxxxx | <2=011>x+} Allow any
length of number with leading digit 2 and 10 digit-numbers
of leading digit 1 and leading exchange number between
2 and 9; if leading digit is 2, replace leading digit 2 with
011 before dialing.
3. Default: Outgoing - {x+}
