20
Step 7
Slide a clevis retainer onto a nylon clevis.
Thread a clevis onto an 18
1
/
8
" (460mm)
pushrod wire, a minimum of 10 turns.
Step 8
Install the servo hardware (grommets and eyelets)
included with the servo. Mount the throttle servo with
the output shaft towards the rear of the fuselage.
Step 9
Slide the pushrod into place from inside the
fuselage and attach the clevis to the servo arm.
Step 10
Move the carburetor to the half-throttle position.
Mark the pushrod where it crosses the throttle
arm using a felt-tipped pen. Remove the pushrod
and make a “Z” bend in the pushrod.
Section 6: Engine Installation
