Hangar 9 FuntanaX 100 ARF, Инструкция по сборке

Страница: 29 / 44

29

Step 7
Test fit the 16
3
/
8
" (416mm) outer pushrod tube through
the firewall and into the fuselage. Once satisfied with
the fit, roughen the tube using sandpaper. Slide the
tube back into position and use medium CA to glue
it to the firewall. Allow 1/16" (1.5mm) of the pushrod
to extend forward of the firewall. Trim the throttle
pushrod at the front edge of the throttle servo tray.

Step 8
Slide a clevis retainer onto a nylon clevis.
Thread a clevis onto the 18
5
/
8
" (473mm)
pushrod wire a minimum of 10 turns.

Step 9
Install the servo hardware (grommets and eyelets)
included with the servo. Mount the throttle servo with
the output shaft towards the rear of the fuselage.

Step 10
Slide the pushrod into place from inside the
fuselage and attach the clevis to the servo arm.
Section 7: Engine Installation