Hangar 9 FuntanaX 100 ARF, Инструкция по сборке

Страница: 18 / 44

18
 
Step 4
Plug in the elevator servo and turn on the radio
system to center the servo. Place the servo
arm on the elevator servo as shown.
 
Step 5
Use two hinges to temporarily attach the elevator to the
stabilizer, aligning the tip of the elevator with the tip of
the stabilizer. Use tape to hold the elevator in position
for the next step. DO NOT glue the hinges at this time.
 
Step 6
Remove the back plate from one of the control horns
and connect the clevis to the center hole. Position the
control horn so the holes in the horn align with the
hinge line. Having the linkage attached will allow you to
position the linkage parallel to the side of the fuselage.
Transfer the location of the control horn mounting
holes onto the elevator using a felt-tipped pen.
 
Step 7
Remove the elevator and use a drill and 3/32" (2.5mm)
drill bit to carefully drill the holes for mounting the
control horn. Apply 2–3 drops of thin CA into each of
the three holes. This will harden the wood and prevent
the screws from crushing the underlying wood.
Section 4: Elevator Installation