Hangar 9 FuntanaX 100 ARF, Инструкция по сборке

Страница: 10 / 44

10
 
Step 7
Slide the aileron and wing together. The gap between
the aileron and wing should be approximately 1/64"
(.4mm). Use a ruler to align the end of the aileron to
the wing, leaving enough gap so the aileron will not
rub against the tip force generator. Also check that the
aileron can move freely and not bind at the wing root.
Note : Do not use CA accelerator during
the hinging process. The CA must be
allowed to soak into the hinge to provide
the best bond. Using accelerator will not
provide enough time for this process.
 
Step 8
Remove the T-pins and apply Thin CA to each hinge.
Make sure the hinge is fully saturated with CA. Use
a paper towel and CA remover/debonder to clean
up any excess CA from the wing and/or aileron.
 
Step 9
Firmly grasp the wing and aileron and gently pull
on the aileron to ensure the hinges are secure and
cannot be pulled apart. Use caution when gripping the
wing and aileron to avoid crushing the structure.
 
Step 10
Work the aileron up and down several times to work
in the hinges and check for proper movement.
Section 1: Aileron Installation