Hangar 9 Extra Easy XE2, Инструкция по эксплуатации

Страница: 16 / 24

16
Starting the Evolution Engine
(continued)
Step 2. To prime your engine, first turn on your transmitter
and then your receiver. Move the throttle to full open and place
your finger over the carburetor opening. Turn the propeller over
by hand six full turns thus priming the engine. Move the throttle
stick full down to idle.
Caution: Always have a helper hold your plane when
starting.
Step 3. Move the throttle trim lever to the middle position.
Place the glow driver on the glow plug and using a start stick
turn the propeller counter clockwise through the compression
stroke. You should feel a bump against the start stick. When
you feel the bump, flip the propeller counter clockwise to start
the engine. Repeat the process if the engine does not start.
Step 4. Allow the engine to idle for 30 seconds. Adjust the
trim lever if necessary to achieve a constant idle.
Note: The flywheel will allow the Evolution engine to
idle reliably at incredibly low speeds. With the glow
driver still attached advance the throttle to full throttle
and then back to idle. Remove the glow driver.
Step 3 photo