Hangar 9 Extra Easy XE2, Инструкция по эксплуатации

Страница: 10 / 24

10
Section 4: Installing the Propeller on the
Evolution Trainer Engine
(continued)
Step 3. With the flywheel in place, install the spinner back
plate onto the engine as shown.
Note: The flywheel is keyed in place onto the engines
crankshaft and should be tight against the front engine
bearing.
Step 4. Slide the propeller onto the engine with the molded
“E” facing forward as shown.
Step 5. Install the prop washer and prop nut removed in
Step 1. Make sure to position the beveled edge of the washer
forward.
Step 6. Using an adjustable wrench, tighten the prop nut
while holding the propeller in place.
Warning: The propeller must be securely tightened
before attempting to run your evolution engine. Be sure
to check the security of the propeller before each flying
session.
Note: The propeller must be positioned to allow the
spinner cone to fit into the slots in the back plate. Test
fit the spinner cone before attempting to install the self-
tapping screws of the spinner.