![Hangar 9 Cessna 182 Skylane Скачать руководство пользователя страница 22](http://html2.mh-extra.com/html/hangar-9/cessna-182-skylane/cessna-182-skylane_instruction-manual_3607169022.webp)
22
Step 9:
Remove the horizontal stabilizer and the vertical fin and
carefully cut away the covering with a sharp hobby knife inside
the lines you marked in Step 7.
Caution:
Be careful not to cut into the wood as doing so
would weaken the structure. A straight edge is
helpful here.
Step 10:
Insert the horizontal stabilizer into the fuselage and
position it in the approximate location. By sliding the stabilizer
slightly in and out of the opening, you can apply the epoxy. Mix
up approximately 1/4 ounce of the 30-minute epoxy and apply it
to the top and bottom of the horizontal stabilizer where the
fuselage comes in contact with the stabilizer. Wipe away any
excess epoxy with a paper towel and rubbing alcohol.
Step 11:
Apply 30-minute epoxy to the vertical fin where the
fuselage contacts the fin. Also apply epoxy to the base of the fin
where it keys into the horizontal stabilizer. Insert the fin into the
fuselage in approximately the correct position and wipe away
any excess epoxy.
Step 12:
Precisely align the horizontal stabilizer and vertical fin
as before, using masking tape to hold the stabilizer and fin in the
correct alignment. Double check the alignment and allow to fully
cure over night.
CONTINUED
Section 6: Installing the Tail
Содержание Cessna 182 Skylane
Страница 48: ...Copyright 1998 Horizon Hobby Distributors Inc...