Hangar 9 Cessna 182 Skylane, Инструкция по эксплуатации

Страница: 15 / 48

15
Step 1: Turn the wing upside down. From the aileron servo
control arm that is attached to your servo (if it’s not attached, do
so now), use a felt tipped pen to mark the location of the control
horn directly in-line with the control arm as shown. Remember
to locate the control horn so the holes are directly above the
hinge line of the aileron.
Step 2: Place the center of the control horn on the aileron at the
mark made in the previous step. Mark the hole positions of the
control horn.
Step 3: Remove the control horn and drill two 1/16
″
holes
through the aileron as marked.
Step 4: Attach the aileron control horn using the hardware
provided (two long screws and back plate) and fasten it in place
using a small Phillips screwdriver
Step 5: Repeat the marking procedure for the other aileron
Step 6: Locate two of the short threaded rods (1/16
″
x 7
7
⁄
8
″
).
Thread a clevis at least 16 turns onto each rod. Be sure they are
not the longer rods.
Section 4: Installing the Aileron Linkage
• Wing assembly from Section Three
• Aileron linkages, 1/16
″ ×
7
7
⁄
8
″
(2)
• Control horns with linkages (2)
• Drill
• 1/16
″
drill bit
• Z-bend pliers (optional)
• Small Phillips screwdriver
• Felt tipped pen
• Pencil
• Masking tape
• Fuel tubing (optional)
Parts Needed Tools and Adhesives Needed