Hangar 9 Cessna 182 Skylane, Инструкция по эксплуатации

Страница: 11 / 48

11
Step 6: Coat one half of the dihedral brace with epoxy up to the
pencil line drawn in Step 1. Note the orientation of the V side of
the dihedral brace; the V must face up. Install the epoxy-coated
side of the dihedral brace into the wing joiner cavity of the wing
half up to the center line, making sure the V of the dihedral brace
is positioned correctly.
Step 7: Apply a generous amount of epoxy into the wing cavity
of the other wing half.
Step 8: Now apply epoxy to all sides of the exposed area of the
dihedral brace and uniformly coat both wing roots with epoxy.
Step 9: Carefully slide the two wing halves together. Firmly
press the halves together, allowing the excess epoxy to run out.
Using rubbing alcohol and a paper towel, clean off the excess
epoxy. There should not be any gap between the wing halves.
Note: It is a good idea to place a sheet of wax paper under
the wing’s center joint so any excess epoxy doesn’t
adhere to the surface of the work area.
CONTINUED
Section 2: Joining the Wing Halves