Step 5
De-Rattler Knob
Main Shaft Housing
Height-Selector Locking Pin
2
3
Figure 12
1
2
3
1
Proper Resting
Position
Figure 13
1
1
Crossbar
2
2
Insert the Main Shaft (NX-1630) into the Table Bed (EP-1140)
• Loosen the De-Rattler Knob on the Main Shaft Housing.
• With the height adjustment settings on the Main Shaft facing up, slide the end of the Main Shaft into the Main Shaft
Housing on the Table Bed.
• Pull out the height-selector locking pin to allow the Main Shaft to slide in farther (Figure 12). For the purpose of
easy assembly, slide in the Main Shaft and release the pin in the last height setting (Refer to the Owner’s Manual for
proper height adjustment before use).
NOTE: The De-Rattler Knob is an optional accessory that helps prevent a slight shift in the table when you invert.
The security of the product is not compromised if you choose not to tighten the knob.
• The Main Shaft must rest against the Crossbar of the A-Frame (Figure 13). The Crossbar prevents the table from
rotating forward when the user steps on the Foot Platform. If the Main Shaft does not rest on the Crossbar as
shown in Figure 13 then the Table Bed has been assembled backwards onto the A-Frame and this must be
corrected before use.
Step 6
Attach the EZ-Angle Tether Strap (F5-1008) to Limit the Degree of Rotation
• Hook the clip at the end of the tether strap to the loop at the base of the table bed (Figure 14) to limit your degree
of rotation.
• Adjust the EZ-Angle Tether Strap to a comfortable angle of inversion for your experience level:
20° / Twenty Degrees
– adjust the strap so the
green
stripe is in the center of the sliding buckle for inversion to a gentle
twenty-degree angle.
40°/ Forty Degrees
– adjust the strap so the
orange
stripe is in the center of the sliding buckle for inversion to a
moderate forty-degree angle.
60° / Sixty Degrees
– adjust the strap so the
red
stripe is in the center of the sliding buckle for inversion to a more
advanced sixty-degree angle. This is the angle when full decompression is realized.
90° / Ninety Degrees
– Remove the tether strap clip from the base of the table bed loop to enable rotation to full inversion.
Figure 14
