Figure 1
Spreader Arms
1
Crossbar
2
Assemble the A-Frame Base (EP-1100) and Install the Handles (GL-9518,GL-9522) and Shrouds (GL-9524)
• Open the A-Frame and make sure the Spreader Arms are locked. Rest the A-Frame on the floor (Figure 1).
The Crossbar is at the front.
• Insert two double threaded bolts (GL-9523) through the base of the Left Handle (marked with an “L”) and hand
tighten on the outside with the nuts provided (Figure 2). Line up and insert the opposite end of the bolts through the
corresponding 1/3” holes on the outside of the hinge plate. Loosely tighten with nuts, then use the wrenches
provided to tighten both sets of nuts, being careful not to over tighten. Repeat with Right Handle.
• Place each shroud (GL-9524) over the outside edge of the corresponding handle. Line up and insert the shroud bolts
(GL-9525) through the smaller 1/4” holes in the hinge plate (Figure 2). Use the wrenches provided to tighten the
nuts, being careful not to over tighten.
Step 1
Back
Front
2
1
Figure 2
Right
Left
Bolts will come pre-assembled in handles and shrouds.
