Figure 10
Attach the Table Bed (EP-1140) to the A-Frame (EP-1100)
• Holding each side near the Roller Hinges, pick up the Table Bed and stand at the front of the A-Frame where the
Crossbar is located. Lower each Pivot Pin into the A-Frame hinge plates one at a time (Figure 9). You may need
to push outward on the A-Frame in order to slide the second Pivot Pin into the hinge. Figure 10 shows the correct
placement of the Pivot Pin into the hinge plate.
• Make sure that both Pivot Pins are seated at the base of the slot in the hinge plate. Check to make sure that the
self-locking hooks have closed over both Pivot Pins (Figure 11), and the table rotates smoothly.
Step 4
Figure 9
Figure 11
WARNING
!
Failure of the self-locking hooks to close over both pivot pins is indication of improper
assembly and if not corrected could result in serious injury or death!
