Handy Home Products 16691, Инструкция по эксплуатации

Страница: 18 / 20

18 Monterey
aA
INSTALLING DRIP EDGE,
SHINGLES, METAL CAP
AND SPINDLE
❑
6 Bundles Shingles (not included) for 10’
❑
8 Bundles Shingles (not included) for 12’
❑
10 Bundles Shingles (not included) for 14’
❑
50 feet Drip Edge (not included) for 10’
❑
60 feet Drip Edge (not included) for 12’ and 14’
❑
1 Pc. Metal Oval Cap
❑
2 Pcs. Finial
Upside down
starter course
3/4" Roofing
Nail
First course
Utility Knife
Making Ridge
Cap
Cutting angle
on Ridge Cap
Ridge Cap
Installing Ridge Cap
1" Roofing Nail on
Ridge Cap
3/4"
Roof nails
Snip at
corner
Drip
Edge
11-A
Fig.1
Fig.2
Fig.3
Fig.4
Caulking the Roof Seams before
shingling will improve the water
resistance of your Gazebo.
Fig.5
11-A: Install the recommended Drip Edge
around the perimeter of the Roof Panels before
shingling the Roof. Use 3/4” Roofing Nails to
install Drip Edge. Snip the top of the Drip Edge
at corners and bend to meet next Roof Panel.
Install a starter course of Shingles consisting of a
row of Shingles turned upside down. Attach with
3/4” Roofing Nails that are supplied with kit.
After starter course is completed, cut excess
shingles off along seam of Roof Panels with
Utility Knife as shown in 11-A. Next, place first
course of shingles directly over starter course in
normal position and nail with 3/4” roof nails. Cut
excess material off in the same manner as
starter course. Continue up Roof Panel, overlap-
ping Shingles as you go and cutting off excess.
To create Ridge Caps, take a shingle and cut it
into six equal pieces as shown in Fig. 1. Cut
about 1/3 of Shingle at top on an angle as shown
in Fig. 2. Install Precut Ridge Caps (Fig. 3) over
seams where the excess Shingle material was
cut off, making sure to cover each of the angled
cut ends of the Ridge Cap. Attach each Ridge
Cap with two 1” roof nails supplied with kit (Fig.
4).
Place Metal Roof Cap on top of shingled Gazebo
and install Finials through hole in cap and screw
down snugly (Fig. 5). Pre-drill with 3/16” bit for
dowel screw into Finial Block.
CAUTION: Use 3/4”
Roofing Nails when
installing layers of
shingles.