HandTop HT3200-UV K Series, Инструкция по установке

Страница: 108 / 113

107
Image 7
When the rectify roller is moving right or left, the swing mounting plate in the
bottom will trigger one of the micro-switches, the servo motor will stop working, the
rectify roller will stay in right or left and stabilize the belt movement continuously.
(See image 6)
Only when both green lights on the focusing photoelectric switches are on or off,
and above rectify device is not able to correct the conveyor belt deviation, can we
adjust the belt tightness through the adjusting screws on both sides of the slave
roller. When adjusting them, use a Allen key to tighten both sides. Give even
strength for both sides in the beginning, manually control the tension. (See image 3
and 4)
Start up the machine, observe the belt swinging status. A. the rectify device is in the
right limit, if the belt is moving left (Reference from the backside of the machine),
means the rectify process is correct. If the belt is shifting fast, tighten the left a bit
or loose the right side a bit. If the belt is shifting to the right side, this means the
rectify is wrong, need to tighten the right side and loose the left side until the belt
shifting to the left side. B. Same principle when the situation is in contrary.
When the rectify device is in control of the belt, continue to adjust slightly with
the alley key until the belt deviation is in sufficient control.
Left
Right
Rectify
roller
L/R Micro-switches
Swing mounting
plate
Ball screw nut