Hands Free Farm RANGER, Руководство пользователя

Страница: 6 / 24

INSTALLING RANGER
HANDSFREEFARM.COM
4
Installing RANGER
Note: Proper installation is critical for safe and optimal RANGER operation.
The following sections represent typical installation order; however, install components in your preferred order.
Mounting the Antenna
Mount the antenna in a location that will optimize its performance—typically along the
left/right centerline of the vehicle as high and as far forward as possible (usually along
the leading edge of the vehicle cab). Do not place the antenna within two feet of a
transmitting radio antenna (such as a two-way or business band radio).
To mount the antenna:
1. Clean and dry the vehicle surface where you will attach the antenna
mounting plate.
2. Remove the paper backing from one side of the adhesive disk then
affix the disk to the bottom of the antenna mounting plate.
3. Remove the other paper backing from the adhesive disk (see at
right).
4. Position the mounting plate in your preferred location then press
down hard for proper adhesion.
5. Place the magnetic mounted antenna on the plate, making sure the
antenna is on the left/right centerline of the vehicle (see at right).
Routing the Antenna Cable
When routing the antenna cable:
• Make sure the RANGER console is powered off before attaching the cables.
• DO NOT bend the cable to a radius of less than 6”.
• DO NOT route the cable within 12” of radio wires, power generator wires, a heat source, or moving parts.
• Coil excess cable in a protected location and secure the installation with tie straps.
To route the antenna cable:
1. Route the cable through a cab opening where rubber
protection exists that will protect the cable (see top right).
2. Attach the other end of the antenna cable to the console (see
bottom right).
Antenna
Attach antenna
cable here