HANDSFREEFARM.COM
13
USING RANGER
To set Correction Type, SBAS Satellite, Unite of Measure, or Language:
1. From the Service menu, press the down arrow until the item you want to edit is selected. When you first
displays the Service menu, Correction Type is selected.
2. Press
ENTER
to make the item editable.
3. Press the up/down arrows to change the value, then press
ENTER
to confirm the change.
4. Press
MENU
twice to exit the menu (return to ‘Ready’ screen).
To set NMEA Port Setup options:
1. From the Service menu, press down arrow until NMEA Port Setup is selected.
2. Press
ENTER
. NMEA Port Baud is selected.
3. Press
ENTER
to make the item editable, press the up/down arrows to change the value, the press
ENTER
to confirm the selection and return to the Service menu with the same item (NMEA Port Setup) selected.
4. Repeat steps 1 through 3 for each message (starting with GGA) that you want to change the message
output rate.
5. Press
MENU
three times to exit the menu (return to ‘Ready’ screen).
To reset default settings:
1. From the Service menu, press down arrow until Reset Defaults is selected.
2. Press
ENTER
twice. * Please Wait * appears briefly then Reset Defaults is selected.
3. Press
MENU
twice to exit the menu (return to ‘Ready’ screen).
Using Straight Guidance
Drive the first pass along a straight side of the field or down the middle of the field to divide the field with a straight
swath working out to each side.
Tip!
Before driving A=B lines to work your field, you typically drive a perimeter along the edges of the field. You
must use Contour guidance mode to drive the perimeter. This calculates the field area at the same time. See
“Calculating the Area of a Field” on page 15.
Driving an A=B Line
An A=B line is an imaginary line that passes through two points to define the
first pass. All other passes are uniformly spaced on both sides of the first pass.
Once an A=B line is established, RANGER generates an invisible array of
equally spaced swath lines in multiples of the swath width parallel to and
emanating from both sides of the A=B line (see figure at right) and provides
guidance along any line you steer the tractor to.
While turning around at the headland, the nearest pass number is displayed.
You can work passes in any order.
Note: Remember to press STOP Guidance when you no longer want
RANGER to guide (no longer log data).
A
B
4
3
2
1
0
1
2
3
4
Содержание RANGER
Страница 1: ...User Guide...
Страница 2: ...PN 875 0416 01 Rev A...
Страница 23: ......
Страница 24: ...www handsfreefarm com...
