handi quilter Infinity 26, Руководство пользователя

Страница: 72 / 90

HQ Infinity User Manual
| 7 1
The needle is not positioned
properly
• Position the needle properly to the needle bar. Inspect the
position of the needle to make sure the needle is at the 6 o’clock
position. When you stand directly in front of the needle (facing the
bobbin case side of the machine), you will see the entire needle
eye directly facing you. This is 6 o’clock position.
• Make sure (a) the needle is installed all the way into the needle
bar to the needle-stop hole in the needle bar, (b) the long groove
in the needle is toward the front (bobbin case side), and (c) the
scarf (scooped out part of the back of the needle) is toward the
back of the machine.
• The needle can sometimes be rotated to 5 o’clock (slightly right)
or 7 o’clock (slightly left) to adjust for a more positive thread loop
pickup by the hook point.
Improper threading • Ensure that the machine is threaded correctly.
The Needle Breaks Corrective Measure(s)
The needle is bent or not
installed properly
• Replace the needle. Make sure that the needle is pushed into the
needle bar clamp until it can go no farther. Visually check that it is
up to the top of the stop/sight hole above the needle bar clamp
screw. If the needle isn’t installed properly, it can cause damage in
the bobbin area and throat plate.
The needle hits the throat plate • Correctly position the needle, throat plate, or hopping foot.
Replace with a new needle.
Stitches are Puckered Corrective Measure(s)
The tension is not balanced • Balance the tension of the needle thread after ensuring the
bobbin tension is adjusted correctly. (For more information about
adjusting tension, see Bobbin and Bobbin Tension and Easy-Touch
Tension™ i n t h e Using Your Machine section of this manual.)
Needle too large for quilting
fabric
• Replace the needle with a size better suited for the fabric.
Poor Stitch Quality Corrective Measure(s)
The tension is not balanced • Balance the tension of the needle thread after ensuring the
bobbin tension is adjusted correctly. (For more information about
adjusting tension, see Bobbin and Bobbin Tension and Easy-Touch
Tension™ i n t h e Using Your Machine section of this manual.)
Bobbin case is damaged,
corroded, dirty, etc.
• Since thread slides over the surface of the bobbin case at a high
speed, make sure the case is free of any lint or foreign matter that
could impede thread passage through the machine.