US-501 operation manual
US-501 R02 13.07.09 Display version 4, PLC version 4
P.20 of 31
>
Basic Operation (cont.)
>> Pattern Cutting
1
press here to select the machine for normal or pattern cutting mode (default for continuous cutting)
R2
2
it is for setting the pattern cut repetition times (1=1 needle pitch, range 1 to 100)
3
it is for setting the initial spacing skip steps prior for the first cut (1=1 needle pitch, range 1 to 100)
4
setting the pattern cutting length steps (1=1 needle pitch, range 1 to 100)
5
setting the pattern cut slot spacing steps (1=1 needle pitch, range 1 to 100)
6
to next page
Using different pattern cutter to achieve different pattern (standard pattern cannot bigger than
3mm x 2mm). Adjusting the pressure between the cutter & the sonic horn can also achieve
different welding & cutting point. Application for pattern cutting including decoration and
sewfree button holes.
R2: When the machine is selected to the pattern cutting mode, it will stop when the set cycles are finished
and ready for the next cycle start up.
Continuous Mode
5
3
2
4
1
6
Pattern Cutting Mode
