AI-118 operation manual
issue 1 19.10.07 display version 07 . plc controller version 07
P.33 of 50
Figure 23 Parameter Page -2
1. Jog Speed.
Set the motor speed when pressing the right foot pedal only, at this time the air gun
will not swing in, but the upper and lower rollers will run and bring the tape forward.
2. Foot hold.
On: Press the right pedal to activate the cutting function, the machine will run
according to the parameters of tape end after the tape is cut, and this can ensure that
the tape end part is reliable and beautifully fit.
Off: After pressing the right pedal and starting the cutting function, the machine action
is controlled by the operator. The set parameters in the tape end part are all invalid
except the jog speed.
3. Quill latch.
On: After the cutting is completed, the upper wheel stops at the upper position and
does not press down, which is convenient for the operator to place the material. This
is a very important function of the machine. The upper wheel stops at the upper
position, and the operator puts the material in place. After that, you can directly step
on the left pedal. At this time, the upper wheel will start to rotate and fall according to
the parameter setting of tape start, so it can ensure that the tape is reliable and
