AI-002 operation manual
Issue 1 21.09.09 display version 13 . main controller version 69 . servo version 61
P.57 of 59
Appendix D . Tape Start, Tape Middle, Tape End Parameters
> Tape End Program (cont.)
> Tape End Program > after cut nozzle retract
This setting controls the timing and the retract speed of the nozzle after tape is cut. Position is a
reference number that is reset to 0 after tape is cut. With the upper roller continue to rotate after
the cut, this reference number also increase. A smaller setting will make the nozzle retract
quicker after the cut. A larger setting makes the nozzle retract later at tape end. The speed
setting controls the speed of nozzle retract. This is used to control the heat absorption of the
tape end.
