Page 11
DAS72.1MKIII Manual v 4.xx
SET UP AND CALIBRATE SPAN FUNCTION / DISPLAY INPUT SIGNAL IN mV/V - See Next Page
ENABLE ZERO BUTTON / CALIBRATE ZERO POINT (Continued)
0
T
1
0
T
1
T
T
T
2
NOT YET IMPLEMENTED
.
0
T
1
0
T
1
T
T
T
2
ADJUST ZERO RANGE
Use this menu point to adjust the allowable zero range.
RIGHT keys to set the zero range and store by pressing the enter key. The default
value is set to ± 2000 counts. If the zero value you are trying to set is outside the
range you will get the ‘Err 2’ message on the display.
Use the UP/DOWN & MOVE
0
T
1
0
T
1
T
T
T
2
ENABLE STORING OF ZERO VALUE (NON-VOLATILE)
Use this menu point to enable (0 - on) the storing of the zero value in memory. This
will prevent the loss of the zero value in the event of a power failure. There are 2
possible settings 0 - off (factory default) zero storing not enabled or 0 - on zero
storing enabled. Use the UP or Down keys to change between the settings.
3
4
3
4