Hand Held Products IMAGETEAM 4400, Руководство пользователя

Страница: 36 / 182

2 - 16
Power Saving Mode
This provides control of the Imager’s power consumption, as follows:
Low Power draws low LED current during image capture, allowing one read
attempt
only for each trigger pull. The Imager is less tolerant of hand movement
during the read attempt, and powers down after the image capture is complete.
Medium Power draws a normal LED current during image capture which
enhances motion tolerance.
Medium Power attempts to read as long as the
trigger is pulled, going into a “doze” (low power) state after each read attempt.
The Imager powers down ten seconds after the image capture is complete.
Normal Power draws a normal LED current, attempting to read as long as the
trigger is pulled. The Imager doesn’t go into a “doze” state after each read
attempt, but may power down after two minutes if Power Hold Mode is turned Off.
Power Hold Mode
Power Hold On keeps the Imager in a ready to read state. To conserve power,
this selection may be turned
Off and the unit will power down if not used within
two minutes. When you are ready to use the Imager again, restore power by
pressing the trigger.
Low Power Medium Power
* Normal Power
On * Off