Hampton H35 Direct Vent Freestanding Gas Stove
29
C)02-44
Pins on Rear Log Support
A)02-43
B)02-56
3)
Place Rear Log A)02-43 on the two pins on
the rear log support.
4)
Place the Middle Left Log B)02-56 on the
two pins as shown.
5)
Sprinkle some lava rock just in front of B)
02-56 on the burner holes.
lava rock
B)02-56
6)
Place Front Left Log C)02-44 onto the 2
front pins as shown.
INSTALLATION
Notch
Bracket
A)02-43
The bottom right edge of Log G)02-48 must
sit snugly against the bracket. (Front Log
02-45 has been removed so that the
bracket can be seen.)
Side View
G)02-48
E)02-45
11)
Position notch in Front Right Log G)02-48 on
Log F)02-47 and push the bottom right edge
against the bracket on the burner tray.
G)02-48
12)
Test fire to ensure proper light off (make
sure flame flows smoothly from one end of
burner to the other. If there is any flame
hesitation, check that area for any block-
age of the burner port.
F)02-47
E)02-45
A)02-43
G)02-48
D)02-46
B)02-56
C)02-44
Cutout
Pin
D)02-46
B)02-56
A)02-43
7)
Place the Left Top Log D)02-46 on the pin
on Log B)02-56 and on top of the cutout on
Log A)02-43.
E)02-45
C)02-44
8)
Place Front Right Log E)02-45 on the two
pins as shown.
9)
Place the lava rock in the area between the
left and right logs, leaving a space in the
middle for log (F) 02-47.
Cutout
Notch
F)0
2-4
7
E)02-45
A)02-43
10)
Place the notch in Center Log F)02-47 over
Log E)02-45 and across the cutout on Log
A)02-43.
