8
Removing the track head from the track
Operation
Care and Cleaning
CAUTION:
Problem
Possible Cause
Solution
Make sure the power supply is on.
There is a faulty wire connection.
There is a faulty switch.
There are crossed wires, or the power
wire is not properly grounded.
The light bulb will
not illuminate.
Check the wire connections.
□
□
□
□
□
□
□
□
□
□
□
□
□
Use a dry or slightly dampened, clean cloth (use clean water, never use a solvent) to wipe the interior and exterior surfaces of the
Troubleshooting
The fuse blows or circuit breaker
trips when the light bulb is
illuminated.
The light bulb is burned out.
The power is off.
Replace the light bulb.
Check the wiring.
you are not comfortable troubleshooting
wiring problems.
Test or replace the switch.
track head (G) to cool down.
Pull down on the track head connector’s locking tab (J), and twist until
the track head (G) disengages.
□
G
F
J
K
Adjusting the knob
□
2
1
G
For EC8715,
Loosen the knob (K) on the side of the track head (G)
to adjust the lighting direction of the light. Tighten the
knob (K) when you reach the desired lighting direction.
