2
Table of Contents
IMPORTANT SAFETY INSTRUCTIONS
Safety Information
Read all instructions. Save these instructions and refer to them
made.
This track system is not intended for use with a power supply
cord or convenience receptacle adaptor.
This track system must be supplied by a single branch
120 volt circuit.
The track is not intended to be pendant mounted such as by a
stem or cable.
The mounting screws are to be mounted along the track in the
keyhole slots provided.
Disconnect electrical power before adding to or changing the
□
□
□
□
□
□
□
□
□
□
Table of Contents ......................................2
Safety Information ....................................2
Warranty ...................................................
...................................................
3
3
3
.....................................
.....................................
....................................
3
Hardware Included
.....................................
4
Package Contents
Pre-Installation
.........................................
Installation
Operation
g
n
i
n
a
e
l
C
d
n
a
e
r
a
C
........................................8
8
8
5
Troubleshooting ........................................
SAVE THESE INSTRUCTIONS
Before energizing, make sure that the lighting system is clear
of all material which could cause a direct short, and check all
electrical connections to make sure they are secure.
Do not attempt to energize anything other than EC series track
tools, extension cords, appliances, etc. to the track.
Lamp gets hot quickly! Touch only the switch or plug when turning on. Do not touch the hot lamp lens.
Turn off power and allow bulbs
to cool down before replacing.
WHEN INSTALLING OR USING THIS TRACK SYSTEM, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED INCLUDING THE
FOLLOWING:
WARNING
: Do not install this lighting system in a damp or
wet location.
CAUTION:
To reduce the risk of a burn during re-lamping,
remove from the track before re-lamping.
CAUTION:
Hot surface, keep away from curtains or
any other combustible material.
NOTE:
All electrical connections must be in accordance with
local codes and the National Electrical Code. If you are
unfamiliar with methods of installing electrical wiring, secure
CAUTION:
Refer to the re-lamping label located on the
IMPORTANT:
For use with Hampton Bay EC series line
voltage track systems only.
Do not install any part of this track system less than 7 ft.
Do not install any lamps closer than 6 in. from any curtain
or similar combustible material.
□
□
Tools Required
NOTE
:Make sure to install the shade ring after installed the light
bulb.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
□
□
□
□
□
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
□
FCC responsible party name : Lumitific Corporation ./address: 2850 W Horizon Ridge Parkway #200 Henderson, Nevada United
States NV89052 /Telephone number: 678-383-4085.
