Hampshire Controls Corp.
Revision 1.2
Temperature Transmitter Operating Instruction
Page 8 of 21
©2014
Connecting to a Network
If your Temperature Transmitter was not factory-configured to connect to your wireless (Wi-Fi)
network, you will need to perform this configuration step yourself. This section describes the
method used to configure the network connection settings of the Temperature Transmitter.
Web Configuration Mode
In order to use the Web Configuration Mode, you will need a wireless device such as a laptop
computer or a smartphone capable of connecting to an IEEE Standard 802.11B/G wireless
network. Your wireless device must be configured to obtain its IP address using DHCP (see
your devices manual, on-line help, or an IT professional for instructions).
If you have installed the three provided AA batteries in your Temperature Transmitter, it will be
powered on. To enter the Web Configuration mode you must tap the RESET button. The
STATUS LED will illuminate red
. When this occurs, immediately press-and-hold the
DISP/PROG button until the STATUS LED starts flashing red and green
. Release the
DISP/PROG button. When the STATUS LED stops flashing and turns green
the sensor is in
Web Configuration mode.
Now, on your wireless device, go to the wireless
network configuration and search for new wireless
networks. You should see a network with an SSID
similar to HCC-0B73F2, where the last six
characters will be a random sequence containing 0-
9 and A-F. Connect your device to this network as
shown in the adjacent image.
