ADJUSTMENTS
AND
TESTING
ANTEA 50 BT – BTS - BTO
Doc.
10059284
Issued
12/2016
Ver.
AC
Page
23 of 25
Adjusting the Washing Base
(BTS version)
1. Adjust the transversal inclination of the base:
•
position the machine on an even, flat floor
•
lower the base onto the floor with the brushes assembled
•
loosen the
screw and M8 nut
that fix the left lifting arm to
the base
•
rest the base on the floor so that the brushes touch the
floor simultaneously
•
tighten the M8 screw and the locknut
2. Check the
M8 screw
that fixes the arm to the third point
allows the longitudinal movement of the base, so this can
adjust itself to the specific floor.
3. Adjust the pressure relief
spring
by tightening the M6 screw
on the tie rod until 5-6 mm of thread remain, so as to obtain
the correct pressure on the base.
4. Assemble the transmission coupling so that there are
2 mm.
between the two hubs and that the rubber toothed star
situated between the two works properly, no vibrations or
misalignments.
5. Tighten the dowels and related nuts.
6. Adjust
the
drive
belt
tension
by
means
of
the
M8 nut
, so that the thread protrudes from the support by
approx.
28-29 mm.