Hammer A2-26, Руководство по эксплуатации

Страница: 68 / 94

68
Maintenance
10.1 Maintenance schedule
The following maintenance work must be performed at the prescribed intervals.
Chap. Task to execute
Dail
y
Ev
er
y 8 oper
at
in
g hour
s
Ev
er
y 80 oper
at
in
g hour
s
Mont
hl
y
Tw
ic
e a y
ear
Pa
ge
10.3 Clean the machine X 69
10.5 Check kickback guards/clean transport rollers X X 71
10.6 Check belt tension and belt condition X 72
10.7 Drive chain feed rollers X X 73
10.8 Lubricate the thicknessing table height adjust-
ment spindles
X 73
10.9 Check safety devices X 74
10.9 Test the emergency stop if the machine is
equipped with an [emergency stop] button
X 75
10.9 Test the red stop button as the emergency
stop if the machine is not equipped with an
[emergency stop] button
X 75
10.2 Cleaning and lubricating
● Do not use compressed air to clean, as this will blow dust and shavings into
the various ball bearings and guides.
● Only use low dust emission vacuum to remove dust deposits.
● Carry out cleaning when required, after each workday or at the very latest
after 8 hours of operation.
NOTICE
Do not use graphite and MoS2 sprays
Guide tracks could be destroyed.
− Only use High Performance Grease (Art. Nr. 10.2.001) for
lubrication.
NOTICE
Caustic or abrasive cleaning detergents
Damage to the surface of the machine
− Never use caustic or abrasive cleaning detergents.