FITTING THE GRATE
Note : The grate bars are factory assembled,
however during transit, they may have been
dislodged. Please see the instructions below on
grate assembly.
Grate
The grates in the Hamlet Camborne Delux stoves,
comprise of a series of reciprocating cast iron
grate bars, seated on a pivoted „comb‟. All bars in
the grate are identical, but every other bar is
turned through 180 degrees, with the ends of the
bars marked „H‟ sitting on the high sections of the
comb, and the ends marked „L‟ sitting on the low
sections.
Assembling The Grate
To assemble the grate, fit bars to the low sections
of the comb first, inserting ends marked „H‟ into the
rear channel with the groove on the underside of
the bar is located on the up stand tab, and then
lowering end marked „L‟ onto the low section of the
comb, see fig. 3.
The upper bar is fitted in a similar manner, but with
the end marked „L‟ inserted in the rear channel,
and the end marked „H‟ seated on the high section
of the comb. See fig. 4. for the assembled grate
layout.
Grate Bar Replacement
After extended use it may be necessary to replace
some of the grate bars. Periodic inspection of the
bars is recommended and the removal of any nails
or wire that may be present after burning wood. All
the grate bars in each appliance are identical and
can easily be lifted out after the removal of the fuel
retainers. Remove damaged grate bars and re-
place with castings of the same type, fitting as per
the instructions above. When re-ordering
replacement grate bars, see page 31 of these
instructions for the correct spare part code.
INSTALLATION
14
Fig. 3. Fitting The Grate Bars
Fig. 4. Assembled Grate
Hamlet Camborne Deluxe Stoves
