8
Grinder Assembly
1. Remove the Ring Nut, Grinding Plate, Knife and
Auger from the Grinder Head before installing the
Grinder Head to the Main Body.
2. Align the notches on the Grinder Head with the tabs
on the Main body.
3. Insert the Grinder Head into the Main Body and
push the lever down to lock into position. The lever will
be at the lock graphic ( ) when locked (
FIGURE B
).
4. Insert the Auger into the Grinder Head, Auger Driver
end first (
FIGURE C
).
5. Place the Grinder Knife onto the square portion of
the Auger Pin. The cutting edges (flat side) of the Knife
should be facing out (
FIGURE D
).
6. Place the Grinding Plate of your choice onto the
Auger Pin. Ensure the pin of the Grinder Plate fits into
the notch position of the Grinder Head (
FIGURE C
).
7. Turn the Ring Nut clockwise onto the threaded end
of the Grinder Head until it touches the Grinder Plate
and is snug. DO NOT over-tighten the Ring Nut.
8. Place the Tray on the upright part of the Grinder
Head. NEVER use the Grinder without the Tray
installed!
FIGURE B
FIGURE C
FIGURE D
Auger
Pin
Cutting edges of the Knife facing out.
ENTANGLEMENT HAZARD: Disconnect power before
cleaning, disassembling or assembling.
!
WARNING
