10
1. Unplug from outlet.
2. Remove the Ring Nut, Grinding Plate, Knife and
Auger from the Grinder Head before installing the
Grinder Head to the Main Body.
3. Align the notches on the Grinder Head with the
tabs on the Main body.
4. Insert the Grinder Head into the Main Body and
push the lever down to lock into position
(FIGURE
F)
.
5. Insert the Auger into the Grinder Head, Auger
Driver end first
(FIGURE G).
6. Place the Grinder Knife onto the square portion
of the Auger Pin. The cutting edges (flat side) of
the Knife should be facing out.
7. Place the Grinding Plate of your choice onto
the Auger Pin. Make sure the notch of the Grinder
Plate fits into the positioning pin of the Grinder
Head.
8. Insert the Stuffing Funnel through the Ring Nut
and then onto the Grinder Head.
9. Turn the Ring Nut clockwise onto the threaded
end of the Grinder Head until it touches the Stuffing
Funnel. DO NOT over-tighten the Ring Nut.
10. Place the Tray on the upright part of the
Grinder Head. NEVER use the Grinder without the
Tray installed!
ENTANGLEMENT HAZARD: Disconnect power before cleaning,
disassembling or assembling.
!
WARNING
FIGURE F
FIGURE G
Auger
Driver
Stuffer Assembly
