www.hameco.eu
HV-51 User Manual
hameco
20
3. APPLICATION INSTRUCTIONS
3.1 Video Output
3.1.1 Power-On Initial Configuration
Connecting the power, camera will start initial configuration the R indicator light will be flashing. When
the camera returns to the HOME position (middle position for P/T),and lens finishes zooming n/out, the
auto-testing is complete. IR LED will also also stop flashing. If the preset 0 is set, camera will rotate to
the 0 preset position after initial configuration.
3.1.2 Video Output
Connect to the video output cable: the user selects the output mode according to the machine model.
Figure 1.4.1 is for your reference (output interface introduction for each product)
1) network output:
connect this product and your computer through the network cable then open the
browser, enter the camera IP address (factory default 192.168.5.163) in the address bar, in the login
page input a user name and password (factory default are “admin”) . Finally, enter the preview page,
and the image comes out.
(Note: If you forget your user name, password, IP address, you can manually restore the default with
the remote control key combination * #)
2)3G-SDI output or DVI (HDMI) output:
Connect the monitor with the corresponding video output
interface, then the monitor will output the image.
3)USB3.0 output:
Connect this product with computer USB3.0 interface (blue),open the Device Manag
-
er to see whether there is an image device and whether the Universal Serial Bus controllers recognize
USB3.0 device. After being properly identified, open the software, choose the image device and then
it will output the image.
4)USB3.0 compatible with USB2.0 output:
Connect this product with computer USB2.0 interface
(black),open the Device Manager to see whether there is an image device and whether the Universal
Serial Bus controllers recognize USB3.0 device. After proper identification, open the software, choose
the image device and then it will output the image.
