20
9.2 Installing the Rod Stand
As shown in Fig. 17, the LCOS-SLM head consists of a head (main body) and an L-shaped adapter.
The bottom of the L-shaped adapter has a special hole (M6) for mounting the rod stand.
Fig.17
LCOS-SLM Head
The L-shaped adapter has a special hole for mounting various optical adjustment stages. (Fig. 18, A, B, C)
By removing the head (main body), the L-shaped adapter can be attached to various optical adjustment
stages.
【
Removal - Reconnection Procedure
】
1. Use a hex wrench to loosen and remove the LCOS-SLM head front securing screws (M3).
2. Separate the head (main body) from the L-shaped adapter, and attach the L-shaped adapter to the
various optical adjustment stages.
3. Wipe the surface of the L-shaped adapter and the back of the head (main body) with a dry cloth, etc.,
and attach the head (main body) with the fixing screw.
Caution
Do not screw the L-shaped adapter with foreign matter on the surface.
When securing the screws, tighten the four screws evenly.
If unevenly screwed, the silicon substrate may be damaged due to load.
These LCOS-SLM head failures are not covered. Please be careful.
Warning
Do not remove the screws on the back of the head (main body). The
product is not covered by the warranty.