Hamamatsu Photonics C8484-16C, Инструкция по эксплуатации

Страница: 13 / 53

C8484-16C Instruction manual Ver.1.5
11
8. OPERATION
8-1 PREPARATION FOR IMAGING
(1) Connect the equipment as shown in Figure 7-1 before operating of the camera.
• When cables are connected, confirming the power switch of the computer is
the OFF position.
(2) After turning the power switch on, wait approximately 10 minutes for the
temperature to stabilize; this completes preparation for imaging.
8-2 IMAGING
The camera works with following setting after power is switched ON.
Digital data output pixel count 1024
Operation mode Normal readout
Exposure time setting Normal setting
Contrast enhancement gain 0
Digital data output bit count 12 bit
The camera mode and parameters can be changed by command from the host computer,
which transmitted via the CameraLink interface.
8-3 END OF IMAGING
Carry out the procedure below when imaging is finished.
(1) End imaging or transmission of image data.
(2) Turn off the power to the camera and peripheral equipment.