Hamamatsu Photonics C10910, Инструкция по эксплуатации, Страница: 62 / 105

C10910 INSTRUCTION MANUAL Ver.1.19E
60
10-1-3 HORIZONTAL PLUG-IN
Some settings for horizontal plug-in are shown below.
Settings
Model number
M10914-01 M10914-02 M10915-01
Sweep range
(blanking)
- - OFF, 1, 2
Delay - - 0 to 65 535
Trigger mode - - -
Trigger status - - -
Trigger level - -4.0 V to +4.0 V -
Trigger polarity - Rising, Falling -
Settings
Model number
M10916-01 M10916-02 M10916-03
Sweep range
(blanking)
OFF, 100 ns to 100 ms OFF, 100 ns, 200 ns, 500 ns
OFF, 50 ns, 100 ns, 200 ns,
400 ns, 600 ns
Delay - - -
Trigger mode Single, Continuous Single, Continuous Single, Continuous
Trigger status Do Reset, Reset, Triggered Do Reset, Reset, Triggered Do Reset, Reset, Triggered
Trigger level -4.0 V to +4.0 V -4.0 V to +4.0 V -4.0 V to +4.0 V
Trigger polarity Rising, Falling Rising, Falling Rising, Falling
Note
•
In the control software of Hamamatsu, sweep range may be displayed as blanking with
horizontal plug-in.
10-2 MCP GAIN
The electron gain, or image intensity, is directly proportional to the applied voltage to the
MCP. The MCP GAIN can be adjusted in 64 steps, ranging from 0 (minimum) to 63
(maximum). If the MCP GAIN is set to 0, a voltage of 400 V is applied. And when the
setting is 63, the applied voltage is 900 V. Between 0 and 63, the voltage is applied in
linear steps, although the actual gain is exponential. Refer to the TEST REPORT
documentation supplied with your streak camera for the actual measured gain value vs.
voltage setting.
Please note – depending on the Gate Mode settings and if protection function has been
activated, there may be times when this voltage is not applied.