8
English
Introduction
We congratulate you with purchasing this Hamach Buggy 30 and thank you for your trust. This press
can be used for reducing the volume of paper, plastic and empty tins up to 85 %. The Buggy 30 can
be used for tins up to 30 L. Please read the manual carefully. E.M.M. International BV does not accept
responsibility for inaccurate use of the Buggy 30.
The Hamach Buggy 30 is constructed in accordance with the European Norm EN 13736:2003+
A1:2009
(Safety
of
pneumatic
presses),
matching
2006/42/CE
directives.
Technical data Buggy 30
Height
:
185 cm
Depth
:
55 cm
Width
:
55 cm
Press area
:
100 x 42 x 40 cm (H x B x T)
Air connection
:
1/4” G
Air pressure
:
max. 10 bar
Working pressure
:
6 bar
Presstime
:
7 s/6 bar
Piston Pressure
:
650 kg by 6 bar
Wieght
:
101,5 kg
Air consumption
:
20 l/per action
Assembly
Please inspect the buggy 30 unit, directly at arrival, any damages caused by transport should be
addressed to EMM International B.V. on the day of arrival.
The Buggy 30 is delivered on a pallet, after removal of the pallet the Buggy 30 can be placed on the
even floor. It is not necessary to bold the Buggy 30 to the surface it is placed on. The press should be
connected to an oil free air outlet. Manometer should be adjusted by turning, to +/- 6 bar (working
pressure). Connect the press to a compressed air supply (location 084121). We advice customers to
connect the Buggy 30 by a safety coupling, where it’s easy to disconnect the air line in case of
maintanance.
Before pressing any materials, check the functioning of the press, by an empty press cycle. Close the
doors and press the black press button at the right side. Wait till the whole press cycle is completed,
and open the door. Press is ready for us.
The Buggy 30 has a self-lubricating pressure cylinder, which makes additional oiling obsolete.
The Buggy 30 Combipress is equipped with:
Pressure regulator
Manometer
Water separator
Remark:
The press scan only be turned on, if both doors are closed. After closing these will be locked
automatically.
Note: When the compressed airline is removed, the press plate will go back in the lower position. In
this position the door cannot be opened. As soon as the compressed airline is reconnected you can
open the door. This safety circuit is stated in the European Machine Directives for Pneumatic Presses
EN 13736 Paragraph 5.2.1. The Safety System of the Press makes it impossible to open the door
during pressing mode. Don’t try to force it. E.M.M. International BV does not accept responsibility for
inaccurate use of the Buggy 30.
Attention! Only empty tins can be pressed.
