Halma Ocean Optics NIRQuest512-1.7, Инструкция по установке и эксплуатации

Страница: 20 / 50

2: Installing the NIRQuest Spectrometer
12 016-70000-000-02-201603
Connect Spectroscopic Accessories
To find operating instructions on NIRQuest Spectrometer-compatible products such as light sources,
sampling chambers, probes, fibers or any other Ocean Optics spectroscopic accessories, check the the
Ocean Optics website at:
http://oceanoptics.com/support/technical-documents/
Chapter 1: Introduction contains a list of NIRQuest Spectrometer-compatible products. You can find
information related to these products on http://www.oceanoptics.com/ .
External Triggering Options
You can trigger the NIRQuest Spectrometer using the External Software Triggering option through the
30-pin accessory connector on the spectrometer. Only the External Software Trigger mode is available
with the NIRQuest Spectrometer.
The External Triggering Options document contains instructions on configuring External Triggering with
the NIRQuest Spectrometer (see
Product-Related Documentation).
Change the Slit
There’s no need to calibrate your spectrometer when changing the slit, just install and start measuring.
There is one exception to this. You cannot change from a standard slit to a slit with a filter because it
changes the optical focus and wavelength calibration of the spectrometer. In this case you would need to
send the spectrometer back to Ocean Optics. A filter must be ordered for each slit (if your application
requires a filter) and the spectrometer needs to be calibrated and focused with the filter installed. This
only applies to filters installed inside the slit assembly.
►
Procedure
1. Find the SMA connector. If a fiber is attached, remove it.