HALE SmartFOAM 1.7AHP, Описание, установка и руководство по эксплуатации

Страница: 36 / 93

Page 35
SmartFOAM
Figure 13 : SmartFOAM Gear Pump Installation
Although the system is sealed and designed to be
resistant to the harsh environment of fire-fighting
apparatus, a compartment with easy operator access is
recommended.
The base plate of the foam pump and motor assembly
must be anchored to a surface or structure that is rigid and
of adequate strength to withstand the vibration and
stresses of apparatus operation.
The base of the foam pump and motor assembly includes
5/16” (8mm) diameter predrilled mounting holes. The
apparatus mounting location must to be drilled
accordingly. The base plate may be used as a template to
mark mounting hole locations.
Figure 14 : Base Plate Mounting Hole Locations
– 1.7 and
2.1 provides the mounting base dimensions for the
SmartFOAM 1.7AHP and 2.1A foam pump and motor
assembly.
Figure 15
: Base Plate Mounting Hole Locations
– 3.3, 5.0,
and 6.5 provides the mounting base dimensions for the
SmartFOAM 3.3, 5.0, and 6.5 foam pump and motor
assembly.
Make sure the foam concentrate hoses are properly routed
to the inlet and outlet on the foam pump.
Foam concentrate must gravity feed to the foam pump inlet
from the foam tank(s). The foam pump must be mounted in
an area to avoid excessive engine exhaust system heat or
accessory heat build-up.