Hakko Electronics Monitouch S8 Series, Спецификация аппаратного обеспечения

Страница: 73 / 79

6-6 2. Troubleshooting
“SYSTEM ERROR: xx” occurs. The following causes are probable,
depending on the symptoms.
1) Turning the power off and back on
corrects the error.
↓
Communication failed because of
improper timing.
2) Turning the power off and back on does
not correct the error.
↓
A certain condition always causes the
error. Or MONITOUCH is faulty.
If none of the above matches your error,
contact your local distributor.
1) If communication is stable after turning
the power on again, continue and
observe operation.
2) Make a note of the information on error
number, etc. displayed on the screen and
contact your local distributor.
Switches do not work. 1) Switches do not work in the RUN mode.
A beep sounds.
↓
Is the switch interlock enabled?
2) Switch activation position is wrong.
On the I/O Test screen displayed from
the Main Menu screen, press the [Switch
Test] switch. On the touch switch test
screen, a position different from the
pressed position is activated.
↓
The switch activation position may be
misaligned.
3) Switches do not work even in the STOP
mode.
On the I/O Test screen displayed from
the Main Menu screen, press the [Switch
Test] switch. When the touch switch test
screen is pressed, nowhere is activated.
↓
MONITOUCH switches may be faulty.
1) Check the settings of switch functions,
etc. on the V-SFT-5 editor.
2) Perform a touch switch adjustment (page
5-18).
3) Return MONITOUCH to your local
distributor.
The screen becomes dark or
black. 1) Touching the screen restores it to the
previous illuminated state.
↓
The backlight operates automatically as
preset.
2) Touching the screen does not restore it.
However, the POWER lamp is lit.
↓
The backlight may be at the end of its
life. Or MONITOUCH may be faulty.
1) The time for turning off the backlight can
be changed on the V-SFT-5 editor.
2) Return MONITOUCH to your local
distributor.
Screen data cannot be
transferred. 1) An error is displayed on the computer
when screen data is transferred.
↓
There may be errors in the USB
settings.
1) Is the USB driver recognized? Has the
driver been installed successfully (page
2-14)?
If the problem persists, contact your local
distributor.
Symptom Cause Solution