Hakko Electronics Monitouch S8 Series, Спецификация аппаратного обеспечения

Страница: 68 / 79

6
1. Error Messages 6-1
Error Handling
1. Error Messages
There are five kinds of error messages displayed on the S8 series:
1. Communication Error
2. Data Loading
3. Warning
4. SYSTEM ERROR
5. Touch switch is active.
1. Communication Error
When communication is not established between the S8 series and a controller, or any abnormality
(noise etc.) is detected, the following messages are displayed on the S8 series.
* If the above error messages are displayed on the S8 series without establishing communication
between S8 and PLC, test the solution of remark “1”. If the error occurs suddenly in
communication, test the solution of remark “2”.
Error Messages Contents Solution Remarks
Time-Out
Although a request to send is given to a
controller, no answer is returned within the
specified time.
1. Check settings in the [Communication
Setting] tab window of the [Device
Connection Setting] dialog.
2. Check the cable connection.
1
3. Data may be disrupted because of
noise. Fix noise.
2
Parity An error occurred in parity check.
1. Check the cable connection. 1
2. Data may be disrupted because of
noise. Fix noise.
2
Framing
Although the stop bit must be [1], it is
detected as [0].
1. Check settings in the [Communication
Setting] tab window of the [Device
Connection Setting] dialog.
2. Check the cables and wiring.
1
3. Data may be disrupted because of
noise. Fix noise.
2
Overrun
After one character is received, the next
character is received before internal
processing is completed.
1. Check settings in the [Communication
Setting] tab window of the [Device
Connection Setting] dialog. 1
2. Data may be disrupted because of
noise. Fix noise.
2
Check code error
The check code in the controller response
was not correct.
1. Check settings in the [Communication
Setting] tab window of the [Device
Connection Setting] dialog. 1
2. Data may be disrupted because of
noise. Fix noise.
2