28 / 48
Hakki Pilke 43 Pro
Translation
Version 6-2018
4.4.2.
Resplitting or splitting without cutting
1.
Raise the protective cover of the cutting and splitting groove.
2.
Place the log you want to split in the splitting groove.
3.
Close the protective cover of the cutting and splitting groove.
4.
Activate the splitting cycle with button B (Figure 11).
The above procedure can be used to split wood without cutting it as necessary.
4.4.1.
Replacing the splitting blade
Exercise extreme caution when handling the blade, and wear protective gloves.
1.
Pull handle B (Figure 22)
to make it possible to
lower the splitting blade
to the lowest possible
position.
(Note!
the
out-feed
conveyor is A in Figure 22)
2.
Lower the splitting blade
to the lowest possible
position.
If necessary,
remove pieces of wood
from under the blade.
3.
Turn off the machine and
disconnect it from the
power source.
4.
Lift the splitting blade out
of its slot.
5.
Install a new splitting
blade by reversing the
above steps.
Figure 22.
4.4.2.
Adjusting the stroke length of the splitting motion
In the Hakki Pilke 43 firewood processor, the splitting cylinder is controlled electrically with sensors A and
B in Figure 23. The stroke length of the splitting cylinder can be adjusted as follows:
1.
Shut down the machine and disconnect it from its power sources.
2.
Remove the machine’s cover plate, as shown in Figure 23.
