Segmented mandrel T213 – Assembly
6.1 Pre-consideration
Screws are tightened according to the size of the
screw and the general torque.
To avoid axis-parallel warpage under load and to
get stiffness turn in the screws evenly.
To avoid precision error clean the screw joint sur-
faces and also the mating surfaces, see »Mainte-
nance«.
The ex works wetting of the plate surfaces and the
clamping element is only corrosion protection. It's
not functionally lubricated.
The insertion of lubricant is provided only on the
mechanical surfaces. Pay attention to the instruc-
tions for lubricants in the chapter »Maintenance«.
Avoid too much lubricant on the bearing surface, as
this can cause face runout.
Seal rings (e.g. o-ring, quad-ring seal) and sealing
surfaces must be lubricated.
Note the information in the chapter »Maintenance«.
Note that the function surfaces (plate surface, mat-
ing surface, cone surface and seal surface) may not
be damaged.
CAUTION!
Wear safety shoes during the assembly and
maintenance work.
Make sure that the starting of the spindle is im-
possible.
Order h49 7144.907-333
31