Visit our website at
www.alemlube.com.au
or
www.alemlube.co.nz
NSW/ACT
TEL: (02) 9677 1555
FAX: (02) 9675 1155
QLD/PNG
TEL: (07) 3204 9166
FAX: (07) 3204 1224
VIC/TAS
TEL: (03) 8787 8288
FAX: (03) 8787 8266
WA
TEL: (08) 9302 4199
FAX: (08) 9303 2095
SA/NT
TEL: (08) 8241 7111
FAX: (08) 8241 7011
NZ
TEL: (09) 447 1007
FAX: (09) 447 1008
1
Description
The 600A manufactured in Germany, is a lever action 450g grease gun capable of generating up to 12,000 psi. It comes
standard with a 16.5cm rigid extension & 4 jaw coupler for lubricating points. It has a 600g bulk grease capacity & comes
with 4 year warranty. Furthermore, the patented Ever-Flow System enables the gun to be used even with most thick, tacky
greases up to NLGI3.
Specifications
Uses
450g Grease Cartridges, Suction loading, Bulk loader pump from bulk grease drum.
Pressure Capabilities
Up to 12,000psi grease pressure
Delivery
1.6cc per stroke
Operating Instructions
There are two ways to fill the gun with grease:
A: 450g Grease Cartridge:
Unscrew the grease barrel from the gun and insert the 450g grease
cartridge by holding the barrel assembly and pulling the rod back.
Remove cap from the grease cartridge, insert the cartridge into the barrel
and then rescrew the barrel assembly back onto the gun so that the cartridge
sits well against the follower cup. Once in position, press the clamp down
& push the rod firmly back into the barrel.
Important To Note:
When using the gun with a cartridge, the follower cup must be folded back.
The gun is supplied standard with the follower cup in this position.
B: Bulk Grease Loading:
Unscrew the grease barrel from the gun head & insert the barrel into the bulk
grease. Suck the grease up into the barrel by pulling the rod all the way back.
When barrel is full with grease, rescrew the barrel assembly back onto the gun
head so that the follower sits well against the grease. Press the clamp down
& push the rod firmly back into the barrel.
Important To Note:
When using the gun with bulk grease, the follower cup must be folded forward.
To do this, take the follower cup and rod assembly out of the barrel, fold the
follower cup forward and reassemble the barrel assembly.
Maintenance
Cleaning: always keep the follower cup free of impurities. Your grease should be clear
of any foreign particles, dirt etc and the gun should be checked and cleaned regularly.
Trouble Shooting
Air Pocked In Grease: If the gun is pumped but no grease appears from the coupler:
Depress the air bleeder valve on the head and pump a few strokes.
Unscrew the barrel assembly from the gun head with two or three turns and then push
on the plunger rod. With the follower cup engaged the follower cup will move further
down into the barrel venting any trapped air out through the thread connections between
the barrel and head. Unscrew the rigid extension as well.
Safety Warning
Always use safety goggles and gloves when operating this grease gun. Personal injury may occur
and if so seek immediate medical attention. Do not use a high pressure grease fitting as a loader fitting.
Excessive pressure can cause personal injury and equipment damage.
June 2022
Lever Action Grease Gun
OWNER’S MANUAL
600A
