HYDROK – Disassembly
7.2 Disassembling the clamping device
7.2.1 Disassembly of the clamping head
6. x
The changing of the clamping head is only possible in
release position of the stationary chuck.
Special tool required:
Changing fixture
Risk of crushing!
While operating the changing fixture there is
crushing danger.
Do not seize into moving parts!
1. Put the changing fixture on the clamping head: Put
the pins of the changing fixture completely into the
front holes in the clamping head. By operating the
changing fixture the clamping head is squeezed at
the coupling area.
2. Remove the clamping head out of the clamping el-
ement reception and/or the housing.
3. Loosen the changing fixture by light pressure in ax-
ial direction and pull it out of the clamping head.
4. Clean the clamping cone in the clamping element
reception and/or housing.
7.2.2 Disassembly of the HYDROK
5. x
Two people are required.
Special tools required:
Allen wrench
crane and eye bolts from weight 15 kg
Fig. 29
1. Loosen and remove the mounting screws.
2. Disconnect the hydraulic connection at the station-
ary chuck.
3. Remove the stationary chuck from the machine ta-
ble.
Clean the mounting surfaces of the stationary
chuck and the machine table after each disas-
sembly!
Order h49 7144.907-333
77