;>
<0 Irainage pipe elevation
Irainage pipe can be risen up :=7mm5
[hen the downgrade can be sure3 go down slope after being risen up5
accentricity
adjustment/max597mm0
,+
./
B
bent /max50
./
B
indoor unit
hose
hose clamp
I8 Nmrs`kk`shnm ne cq`hm`fd ohod
Nnsulation treatmentA
[rap the hose and its clamp until to the indoor unit without
any clearance with insulating material3 as shown in the
hose
heat insulation
hose clamp
hose
rigid TZH pipe
heat insulation
;0 Mose
Xhe hose is used for adjusting the accentricity and angle of the rigid TZH pipe5
Iirectly stretch the hose to install without making any deformation5
Xhe soft end of the hose must be fastened with a hose clamp5
Tlease apply the hose on horizontal part
Vigid TZH pipe ZT:85<mm /internal diameter0
Koamed TJ with thickness above > mm
Tipe
Nnsulation
:0Qaterial of pipe and heat insulation
Nn order to avoid causing dew3 heat
insulation should be dealt with at gas
side and liquid side5
over 86877
downgrade
Nndoor drainage pipe should be heat insulated5
Xhe connection section with indoor unit must be heat insulated5 Nmproper heat insulation will cause dew5
Irainage pipe is downgrade over 868773 and the pipe should not be crooked3 or noise will occur5
Xhe horizontal length should be no more than 97m5 Nn case of long pipe3 there should be support
for every 85<{9m to avoid unevenness5
Xhe central pipe is executed as the below figure5
Xake care not to put force to the drainage pipe connection section5
Nn order to normal drain3 the drainage pipe should be specified as the installation manual5
Stherwise3 water drop will occur5 Meat insulation is required5
RSXJ
VequirementsA
G
85<m{9m
heat
insulation
over 86877
downgrade
support
W4shape
crooked pipe
ZT:7
as large as possible/about 87cm0
Содержание MRV II AV48NMVERA
Страница 112: ...112 5 Wiring connection among units ...